PMC

Temperature dependence of bulk resistivity of composites. (a) Dependence of TCR on temperature for soda-lime glass/30–70 vol% disk-like Ni-Cr alloy particle composites, compared with that for SUS304, a special cast iron, INCOLOY 800, and a commercial Ni-Cr alloy. (b) Change in the bulk resistivity with increasing temperature for soda-lime glass/30–70% disk-like Ni-Cr alloy particle composites, compared with commercial Ni-Cr alloys and SiC ceramics.

Photographs showing the effects of Fe and Mn additions on edge build-up formation and wear of the cutting drill lip in the G3 alloy after different stages of drilling using the special solid carbide drill. (a) Special solid carbide–new drill. (b) G3 alloy (BUE after 2016 holes) special solid carbide drill.

Top-surface SEM (a) corresponding EBSD grain orientation map (b) of sensitized received Al-Mg alloy after phosphoric acid etching. High-angle GBs (>15°) are denoted by the black lines, while low-angle GBs (≤15°) shown as yellow lines. The special GBs of 13b are marked by white rectangle; (c) Length percent of non-etched/etched GBs with different misorientation angles for sensitized received Al-Mg alloy after phosphoric acid etching.

The clip is 14 mm in diameter and is made of a super-elastic shape memory alloy (nitinol). The clip system consists of the applicator and a special fistula brush